The portable microporous aerator consists of UPVC pipe (or ABS pipe), rubber pipe, inlet branch pipe, inlet soft branch pipe, air flow distributor, inlet branch three-way inlet flexible joint elbow, inlet 304 stainless steel special clamp, load-bearing connecting pipe, etc.
The upgradable aerator is used for oxygenation and aeration in various activated sludge aeration tanks and contact oxidation tanks for urban sewage, industrial wastewater, and drinking water treatment projects.

outside diameter	length	Each set	Tonggan Quantity	service area
65mm	2000mm x 2 pieces/set	4000mm	20-32 cubic meters per set - h	4-8 square meters per set
65mm	1000mm x 2 pieces/set	2000mm	7.0-32 cubic meters per set - h	2-4 square meters per set
65mm	1000mm x 4 pieces/set	4000mm	20-32 cubic meters per set - h	4-8 square meters per set
65mm	2000mm x 1 piece/set	2000mm	10-16 cubic meters per set - h	2-4 square meters per set
65mm	1000mm x 1 piece/set	1000mm	3.4-17 cubic meters per set - h	0.8-2 square meters per set

Product Features
1. The portable microporous aerator uses an aeration tube to hold water, which is integrated with the water to solve the buoyancy design in water;
2. Uniform aeration, fine bubbles, high oxygen utilization efficiency, and high power efficiency;
3. Has good flow velocity and flow state; Low resistance and energy consumption;
4. During aeration, the aerator will swing left and right, which can reduce sludge deposition at the bottom of the tank, minimize dead zone phenomena, increase aeration area, and improve oxygenation capacity;
5. Using rubber film tubes and micro pores in a "U" shape, it has good deformability, avoids blockage, is not easy to break, and has a long service life;
6. Easy to install, can be installed with or without water in the pool, no configuration is required in the pool. If maintenance is needed for long-term aeration, it can be freely lifted and maintained without draining water or shutting down the fan, which does not affect normal operation;
7. No need for air purification, no need for backwashing, no need for vent valves, more convenient management;
8. Various aerators that were originally fixedly installed at the bottom of the pool can be directly transformed into elevating tubular microporous aerators, while keeping the original intake pipeline unchanged.

Product specification design and installation
1. When designing and applying the tubular microporous aerator, the left and right spacing between the air inlet pipes floating on the water surface is 1000-3000mm, and the spacing between the aerators on the straight line of each air inlet pipe is 500-1500mm; the specific distance depends on process conditions such as water concentration, water quality, and gas supply.
2. This aerator can be equipped with single head air intake for up to 10 sets of straight pipes arranged on each DN100 intake manifold; For more than 10 sets of fabric, air intake from both ends can be used, and the specific number of fabric sets depends on the air flow rate.
3. Each intake branch pipe should be distributed from the main pipe on the shore of the pool, and a valve should be installed to bend against the pool wall to the water level inside the pool.
4. The aerator can be suspended and installed about 150-500mm from the bottom of the tank, or according to design requirements.
5. Each intake manifold exchange connection port is connected with a specially designed rubber hose, which has no effect on changes in water level height.
6. The price of this aerator is calculated by set

Responsible for on-site installation. Usage and others
1. After the installation of this aerator in an empty pool, it must be promptly filled with water to avoid exposure to sunlight, welding flames, and heavy objects falling into the pool and damaging the aerator.
2. This product should not be heavily pressed or stored outdoors. It should be kept away from sources of fire and hard objects to avoid damage.