Submersible jet mixing machine:

1. After the submersible mixer stops running, we need to pour the prepared solution into the mixing tank;

2. Press the manual switch to operate the mixer in both forward and reverse directions for 5 minutes;

3. The mixing tank can be cleaned with a brush, and the power supply needs to be disconnected before cleaning to prevent accidental injury;

4. Finally, clean the submersible mixer with water;

5. The body shell can be cleaned with a damp soft cloth, and the operation panel can be cleaned with a dry cloth to prevent water leakage;

6. If the submersible mixer equipment is not used for a long time, it is recommended to apply protective oil to the surface of its body.

In order to better put the submersible mixer equipment into operation, it is recommended that everyone clean the mixer after each operation. Of course, proper cleaning of the submersible mixer is also one of the requirements to extend its service life.

1、 Liquid——Solid

This process refers to the suspended working process according to the physical process. According to chemical processes, it refers to the process of dissolution.

2、 Liquid——Qi

This process physically refers to the process of components. In chemical processes, it refers to the process of absorption.

3、 Immiscible liquid

The physical process refers to the emulsification process, while the chemical process refers to the extraction process.

4、 Miscible liquid

This process physically refers to the mixing process, and chemically refers to the chemical reaction.

5、 Fluid motion

This process physically refers to the pumping process, and chemically refers to the heat transfer process.

The above five mixing processes have their own mixing characteristics, process requirements, and scaling design criteria.

In our usesubmersible mixerIn practical applications, there are often several processes that are used simultaneously, which is a normal operating procedure.

usedivingPush flow mixerThe principle of "four don'ts":

Firstly, do not reverse the motor.

The rotation direction of the motor should be clarified. There are many types of high head submersible pumps that can produce water in both forward and reverse directions, but the water output is small and the current is high in reverse. If the reverse time is long, it will damage the motor winding.

Secondly, do not frequently turn on or off the device.

Do not frequently turn on and off the submersible mixer, as it will generate backflow when the mixer stops running. If you start it immediately, it will cause the motor load to start, resulting in excessive starting current and burning out the winding. Due to the high current during startup, frequent startups can also burn out the motor winding of the mixer.

Thirdly, do not let the submersible mixer work under overload for a long time.

To avoid long-term overload operation of the submersible mixer, do not pump water with high sediment content and observe whether the current value is within the correct range at any time. If the current is found to be too high, stop the machine for inspection.

Fourth, do not work for prolonged periods of dehydration.

The dehydration operation time of the submersible mixer should not be too long to avoid overheating and burning out the motor.

correct usagesubmersible mixerIt can ensure the stable operation of the mixer, improve work efficiency, reduce the frequency of failures, and extend its service life.