Jiangsu mold temperature control machine, oil temperature control machine, water temperature control machine
If selectedJiangsu mold temperature machineTemperature during product moldingMatching requirements can improve product quality and reduce operating costsOil temperature control machineIt is strictly prohibited to add other hydraulic oils inside, and thermal medium oil must be used When adding hot oil to the oil temperature heater It is necessary to confirm that the liquid level is on the oil level gauge Within the lower limit range If it is too low, an alarm will sound If it is too high, it cannot start And the heat medium oil will flow out Causing danger and wasteWater temperature control machineUsing water as the heat transfer medium, there is no need to purchase a heat transfer medium, and it is clean. In terms of operating costs, it is superior to oil temperature machines :(186 )
Introduction to the functions of Jiangsu mold temperature control machine, oil temperature control machine, and water temperature control machine;
Temperature controller: Adopting Omron series temperature controller with built-in temperature control module, P.I.D value can be independently set according to process requirements, with a wide temperature control range and a temperature control of ± 1 ℃
Heating element: The heating wire is introduced in a circular shape and installed in a stainless steel tube. The gap is filled with magnesium oxide powder with thermal conductivity and performance, and the tube is inserted into the tube. It is connected by a flange and placed in the central part of the stainless steel heating barrel. The heating is uniform and does not produce local overheating
Heat transfer pump: Taiwan, China Yuanxin series high temperature pump is adopted, with smooth operation, obvious heat transfer effect and low noise
Electrical components: All electrical components use Schneider series electrical components, with low failure rate and extended equipment use
Control system: microcomputer control, 5-way single-chip circuit board, dual group PID, heating and cooling autonomous operation
The water temperature control machine is a mold temperature machine that uses water as a heat transfer medium. Under normal atmospheric pressure, the boiling point of water is 100 ℃ In the absence of pressure, the control temperature of the water model temperature controller can only be less than or equal to 100 ℃. However, in practical applications, by increasing the pipeline pressure, the temperature control temperature of the water temperature controller can be increased to 180 ℃, thereby expanding the application range of the water temperature controller. The oil temperature control machine is a mold temperature machine that uses heat transfer oil as the heat transfer medium. The oil temperature mold temperature machine is used in situations where the working temperature is ≥ 200 ℃. The oil temperature heating machine is divided into 200 ℃ oil temperature machine, 300 ℃ oil temperature machine, and 350 ℃ oil temperature machine according to the different operating temperatures
Keywords of this article; http://www.mwj1 .. com