Product Description

FC Bond Grinding Testing Machine

FC Bond Grinding Test Mill

Description:

FC Bond Mill is designed by FC Bond to determine the Bond Index, which is a measure of grindability and power required for grinding applications. FC Bond Mills is used in laboratories around the world. Each factory comes with a copy of Fred C. Bond's "Crushing and Grinding Methods" (used to determine Bond Index). This grinder can be used to calculate the grindability of all ores.

According to the required grinding type, the ball mill can be used continuously or at any speed. The FC Bond ball mill is equipped with a worktable, motor, clutch, rotary counter, motor starter * and controls, 12 inch cast iron drum, 44-1/2 pound iron ball (adhesion index test), receiving plate and manual sieve plate.

All materials used are low-carbon steel -1018

The tolerances are as follows:

A shaft with a diameter of 0.00005 inches after welding (total diameter -1.4370 to 1.4375). The diameter/width of the keyway shaft is. 002 and the centerline is. 004* The shaft is screwed in and into the end cap before welding, and processed according to the size after welding.

The outer diameter of the pipeline - inventory diameter ID is inventory with a diameter of 12.030 inches.

The end cap can match pipes with an outer diameter of less than 10 inches and is compatible with the shaft. The end cap is made into the main body (tube) by lightly pressing and fitting.

The average internal size from the end cover to the top cover is within 12 inches, with a maximum of. 100 inches.

Match the installation plate with the outer radius before welding.

The door matches the pipeline, so after installing the gasket, the door radius and pipeline radius ID match each other within 0.015 inches.

After welding, use a standard pillow shaped liner to check the concentricity of all parts - use an indicator to check that the deviation of all parts is within. 005 "- this is the worst-case scenario - mostly check. 003".

After welding, deburr all parts and gently polish them.

The welding shaft support bushing of the end cap, the end of the end cap, and the end of the end cap are fixed on the barrel mounting plate and fused onto the mounting plate of the end cap and welded "T" nut assembly.

*Unless otherwise specified, the starter comes with a 220V starter.