Huizhou assembly line introduces you to the drying assembly line: Dry wet materials are transported to the hopper by a belt conveyor or bucket elevator, and then enter the feeding end through the feeding pipeline through the feeding machine of the hopper. The slope of the feeding pipeline should be greater than the natural inclination angle of the material, so that the material can flow smoothly into the dryer. The dryer cylinder is a rotating cylinder slightly inclined from the horizontal line. The material is added from the higher end, and the heat carrier enters from the lower end, coming into counter current contact with the material. There are also cases where the heat carrier and the material flow together into the cylinder. As the cylinder rotates, the material moves to the lower end under the action of gravity. During the forward movement of the wet material inside the cylinder, it directly or indirectly receives heat from the heat carrier, allowing the wet material to dry, and then is sent out through a belt conveyor or screw conveyor at the discharge end. There is a copying plate installed on the inner wall of the cylinder, which is used to pick up and sprinkle the material, increase the contact surface between the material and the airflow, improve the drying rate, and promote the advancement of the material. Thermal carriers are generally divided into hot air, flue gas, etc. After passing through the dryer, the heat carrier generally needs a cyclone dust collector to capture the materials carried in the gas. If further reduction of exhaust dust content is required, it should be discharged after passing through a bag filter or wet dust collector.

The working principle of a drying line is generally to use far-infrared to heat the furnace, and then the interior is made of ceramic and stainless steel, so that the infrared light can shine on every corner of the furnace, and then uniformly heat up, transferring energy to the object.