conduitelbowInstallation precautions

Wires buried in walls must be threaded through conduit, which is generally optionalPVC conduit/PE conduit: affordable, bendable, and has good insulation performance. In fact, it is very good for most families to choose PVC conduit/PE conduit, but they need to choose a sturdy one. The simple method is to step on it with your foot, and the one that will not be crushed is good. Reminder: Regardless of the type of conduit used, there must be no connectors for the wires inside the conduit.

Circuit renovation should avoid dead lines: even with good circuit quality, it is difficult to guarantee that faults will occur in the future and replacement of lines is necessary. At this time, it is very important to easily pull out and replace buried wires. Therefore, in electrical renovation construction, it is necessary to avoid causing "dead lines" that cannot be pulled in the future:

1. Of course, it is important to use conduit to bury the wires.

2. Circuit wiring should adhere to the principle of "wiring at the nearest distance between the two ends" and avoid unnecessary winding. This not only causes dead wires but also increases the investment in electrical renovation.

3. Do not thread too many wires in a conduit. After threading, you should pull the wires to see if they can be easily pulled.

4. If there are joints in the circuit, a box buckle panel must be left at the joint for easy replacement and maintenance in the future.

5. PVC conduit with a diameter less than 25 should be bent using a pipe bender, and no bends should be added. Right angle dead bends often cause dead lines