Introduction to gasoline power sampler

Power (gasoline) soil sampler, soil sampler is a power (gasoline) soil sampler developed by our factory after carefully listening to the opinions of customers, conducting market research from multiple sources, and under the guidance of experts. The instrument uses gasoline power to greatly reduce the labor of soil sampling personnel, and is known for its fast and easy sampling.

1、 Product Technical Parameters

Engine form: air-cooled single cylinder two-stroke

Engine displacement: 62cc

Maximum power and speed: 1.9kw/6500r/min

Maximum torque and speed: 3.5N.m/5000r/min

Impact frequency: 1500 times/minute

Impact energy: 20-55j

Fuel ratio: 93 octane gasoline to two-stroke engine oil 25:1

Fuel tank capacity: 1800ml

Startup system: manual startup

2、 Instrument features

1. The obtained sample has a large diameter and length, with a sampling depth of 2 meters

2. It is relatively easy to drill into the soil with an impact hammer, and it is not difficult to remove it

3. The sample is located in a relatively loose cylindrical shape, making it easy to remove

4. Columnar soil is difficult to compress (maintain its original state)

5. Collecting a sample can study the entire soil profile

6. Compared to excavating a sampling pit, it saves time and reduces sample damage

7. Can be effectively used for all types of soil

3、 Usage purpose

1. Soil structure description

2. Investigate the root system situation and obtain the impact of depth and density on the roots

3. Detecting the composition and density of undisturbed soil

4. Study the moisture content and dissolved substances of soil for long-term operations

5. Research on the flow of water and dissolved substances, such as the rapid loss of water in soil

6. Archaeological investigation

Operation Instructions for Gasoline Power Sampler

1. First, use a proportioning kettle to mix the mixture in a ratio of 25:1 (pour gasoline into the large compartment and two-stroke engine oil into the small compartment) and pour it into the engine fuel tank. Place the tank facing up and flat for 5 minutes, then press the oil bubbles (transparent plastic bubbles) several times to allow the mixed oil to completely enter the engine from the tank.

2. Install the hexagonal screw and then install the drill bit.

3. Turn on the engine switch by pulling the rope. After the engine is turned on, the drill bit should be lowered vertically into the soil. At this time, it is necessary to control the throttle size (try to control the throttle in the middle position when starting, and adjust the throttle size according to the actual situation), while keeping the engine vertical to the drill rod. Cannot deviate or tilt (deviation or tilt may cause force to deviate and break the drill bit or rod joint).

4. After the drill bit is filled with soil, press the red button to turn off the engine.

5. Remove the engine, hook the slot on the upper end of the drill rod with a crane, pull the chain, and slowly lift the drill bit up. Hook the next section of drill rod with the hook and pull the chain again until it is completely pulled out of the soil layer.

Standard configuration of gasoline power sampler

1. A gasoline powered impact hammer

2. 50mm stainless steel drill bit, 1 piece, 50 * 500mm

3. 3 50cm stainless steel connecting rods

4. A batch of accessories

This article's website: