Corrosion resistant magnetic float level gauge：

Corrosion resistant typeMagnetic float level meterUsing stainless steel body lined with polypropylene (PP) and polytetrafluoroethylene (PTFE) technology, it has high structural strength and corrosion resistance, and can be applied to acidic liquids such as hydrochloric acid, alkaline liquids, and organic solvents. But it is not suitable for measuring concentrated nitric acid, chlorine containing solvents, aromatic agents, aliphatic and other medium liquids. There are two types of side mounted magnetic flap level gauges with stainless steel main body lined with polytetrafluoroethylene (PTFE) and stainless steel lined with polypropylene (PP), which are suitable for measuring corrosive media. The side mounted lined magnetic flap level gauge (PTFE) is suitable for measuring liquid levels in corrosive media and high operating temperatures. It adopts advanced stainless steel lined PTFE stretching and flanging technology, with reliable structure and long service life. It is the best choice for measuring the liquid level of highly corrosive media such as hydrofluoric acid. The PTFE lined magnetic flap level gauge (PP) is suitable for measuring inorganic corrosive liquids such as hydrochloric acid and dilute sulfuric acid. Due to the use of imported high-strength materials that can be close to metals, especially the unique insulation properties of PPR, this product is suitable for outdoor water tank level measurement and will not freeze inside in winter But it is not as good in temperature and pressure resistance as PTFE lining, and this product has a higher cost-effectiveness when the temperature and pressure are lower. Users can use remote transmitters according to engineering needs, which can achieve local digital display and output standard remote transmission electrical signals of 4-20mA to meet the needs of recording instruments or industrial process control. It can also be used in conjunction with magnetic control switches or proximity switchesliquid levelMonitor alarms or control inlet and outlet equipment

Basic parameters:
Measurement range L: 200-12000mm
Measurement accuracy: ± 10mm
Medium temperature: -40~480 ℃
Medium specific gravity: ≥ 0.4
Operating pressure: 0-32Mpa
Medium viscosity: ≤ 0.02Pa. S
Connecting flange: according to technical parameters
Technical parameters: According to design or user requirements
Note: D φ 48-89
D1 diameter of 115 to 200 (depending on pressure)
When L1<300, the level gauge is affected by the installation environment and should be clearly stated when ordering
Installation:
Firstly, check whether the data on the liquid level gauge label matches the ordering requirements. There should be no magnetism within 500mm of the liquid level gauge, otherwise it will affect the normal operation of the liquid level gauge.
2. A shut-off valve should be installed between the liquid level gauge and the container to cut off materials during maintenance and cleaning. When the measurement range is greater than 4m, support points should be added to the container and connected to the support points on the liquid level gauge for reinforcement. The connection method includes flanges or fittings. The main installation must be vertical with an error of less than 3 degrees.
3. Open the drain flange cover and gently insert the magnetic float, paying attention to the arrow pointing upwards (heavy end facing upwards), and do not install it in reverse. Install the sealing gasket and flange cover, and tighten the screws evenly. Install a shut-off valve and sealing gasket between the liquid level gauge and the container interface flange, and tighten the docking screws evenly.

Main technical parameters:

productmodel selection：