Buy second-hand 550 type horizontal screen filtration centrifugeThe drum and screw of the second-hand horizontal screen filtration centrifuge rotate in the same direction at a certain differential speed. The material is continuously introduced into the inner cylinder of the conveying screw through the feeding pipe, and after acceleration, it enters the drum. Below, we will explain in detailSecond hand horizontal screen filtration centrifugeThe method of sealing treatment.

1. Sealing of the hood: As the hood is reversible, reliable sealing measures should be taken at the joint surface with the casing. If the sealing structure or material fails to prevent corrosion, it may cause leakage of liquid and gas phases, causing harm to the environment and personnel. The structure of the sealing groove and the anti-corrosion of the sealing strip should be fully considered for their sealing and reliability in the design and selection. Reliable sealing measures should also be taken for the installation interfaces of additional devices such as feeding tubes, washing tubes, and observation glasses.

2. Sealing of bearing positions: For the sealing of spindle nuts and bearing positions, traditional models had relatively simple sealing measures in this regard and could only achieve relative sealing. As for the spindle nut area, the joint surface between the spindle nut and the drum is generally not equipped with a sealing ring. During the operation of the centrifuge, liquid and gas phases infiltrate, causing corrosion to the spindle cone surface, which may penetrate into the bearing and cause damage to the bearing, thereby affecting the normal use of the machine. The upper bearing cover is usually equipped with a skeleton type sealing structure, but a part between the upper bearing cover and the conical hole of the drum is exposed, and the gas phase in the centrifuge cavity may corrode the exposed surface of the main shaft. The centrifuges used in the pharmaceutical industry mostly separate materials such as solvents, acids, bases, salts, etc. Therefore, when ordering equipment, the sealing requirements of these parts should be fully considered, and dynamic or static sealing structures should be set up to meet the sealing requirements.

3. Sealing of the working area of the transmission belt: Traditional centrifuges have an open transmission belt, with only a protective cover installed at the motor end to improve its usability. However, there is no control over the pollution of the environment caused by dust generated by friction. It is not feasible to use it in a clean area. Therefore, it is necessary to seal the working area of the transmission belt to prevent the leakage of friction dust.The above is second-handSecond hand horizontal screen filtration centrifugeThe method of sealing treatment, I hope our introduction can help you. If you would like to further understandSecond hand horizontal screen filtration centrifugeYou can browse our website and we will provide you with more information.