1. Usage 4-79 typeCentrifugal ventilation fanIt can be used for indoor ventilation and air exchange in general factories and large buildings, and can be used for both gas input and output. The types of gases transported are air and other unnatural gases that are harmless to human health and non corrosive to steel materials. There shall be no viscous substances in the gas, and the dust and hard particles contained shall not exceed 150mg/m3. The temperature of the gas shall not exceed 80 ℃.
2. The fan can be made into two forms: clockwise rotation or counterclockwise rotation. When viewed from one end of the motor and the impeller rotates clockwise, it is called a clockwise cyclone machine, represented by "clockwise"; Rotating counterclockwise is called a reverse fan, represented by "reverse". The outlet position of the fan is represented by the angle of the air outlet of the casing. The 4-79 type fans No.3-12 are all made in one form at the factory, and the user unit installs them in the required position according to the requirements. They do not need to be specified when ordering. The adjustment range for the No.3 air outlet position is 0 ° -225 °, with an interval of 45 °. The adjustment range of the air outlet position for No.3.5-6 is 0 ° -225 °, with an interval of 22.5 °. The transmission mode for No.3.5-6 is A-type transmission; The adjustment range of No.7-8 air outlet position is 0 ° -180 °, and the fan interval is 22.5 °. The transmission mode of No.7-8 is C-type transmission; The transmission mode from No.10 to No.20 is E-type transmission, and the position of the air outlet is fixed in three ways: 0 °, 90 °, and 180 °, which cannot be adjusted and must be specified when ordering. The dual inlet types of No.10~20 are all made with three fixed outlet positions: 0 °, 90 °, and 180 °, and the transmission mode is E-type transmission. Please specify when ordering.
3. Structural characteristics: The No.3-6 fans in the 4-79 type fan are mainly composed of impellers, casings, air inlets, and other parts matched with direct connected motors; In addition to the above-mentioned parts, No.7-20 also has transmission parts, etc. ① The impeller consists of 16 backward inclined circular arc thin plate blades, a curved front plate, and a flat rear plate, all of which are made of steel plates. And it has undergone dynamic balance correction. Good air performance, high efficiency, low noise, and balanced operation. ② The casing is made in two different types, with shells No.3-12 made as a whole and cannot be disassembled; The casing of No.14-20 is made into two open types, divided into two halves along the horizontal plane of the center and connected by bolts. ③ The air inlet is made as a whole and installed on the side of the fan. The cross-section parallel to the axial direction is curved, which allows gas to enter the impeller smoothly with minimal loss. ④ The transmission part consists of a main shaft, a bearing box, rolling bearings, and pulleys. |